2010andrew: hi all.this video is amazing, cause explains the littles dvd players to watch movies that the most use, but I wish to know if there´s a video that explains how to change the gears of a dvd palyer....????? pls, if there´s some video, mail me, tnx!
johngr31: Thank a lot you helped me! I have a question , i can use any rubber or only special that is only for cd drives?
Civille7: I wonder if you could use your DVD player by opening it each time through the manual release hole?
MrHiltondang: Coby 514 Silver codefree
Open DVD tray
Press menu/PBC VCD menu.
Change region one.
Set All Region
Close (when Loading..)
Error code (Invalid Region)
MrHiltondang: Coby 514 BLK Silver codefree
Open disc tray Press 9,7,3,5.
Change one Region.
MrHiltondang: Coby 514 codefree
Change all regions.
Press right arrow of Region 1.
Press up/dn arrow of VCD 3000 HD 3001.
Press mute for info settings.
Press setup to save.
MrHiltondang: How to fix Coby DVD-514
Kenneth Ongena: thx alot thx to this video i now know what to do
machack adim: i had a DVD player which is doesn't working anymore .. it cannot read some disc .. what should i do ?
Lvsunshine72: Help my dvd player just stop playing discs and making werid sounds HELP!!!!!!
gman76utube: I hv a cyberhome 300 player that failed. First check power supply, 5V and 12V that power all the boards. The 5V supply was at ground. Found the PS board had a couple bulging caps, replaced them (16V caps instead of 10V), hooked it back up, powered it up, it works again. However light on front was flickering. Pushed eject button, drawer did not open. Noticed some friction. That was problem. Drawer was stuck, caused motor current and the PS to draw lots of current, causing the caps to stress.
anchorbabydiaperrash: next time I'll think twice about throwing out malfunctioning devices if I can fix them myself...with Youtube help
Raquel Perez Melendez: I fixwd my DVD with this!! so good! :)
didogazeto: glad I helped you ;-)
DangerousNoobz: thanks! i plugged up a hole and BAM! it worked! hahah thanks!
didogazeto: the signal that says the DVD player that it's closed,well the thing that makes it,it's broken :-/
there must be holes in the corner of the place you place the DVD disk,look at them and make sure everything is alright in there
sehnzeleid: Good info, but Coby DVD players are so cheaply made the loader mechanism is honestly junk to begin with. I have much older players with massive amounts of use that still load flawlessly. Heck, that Panasonic VCR sitting below it is much better made mechanically by comparison.
DangerousNoobz: Can someone help me? I recently tried to use my portable dvd player. I opened the disk thing and put a dvd in. Then i closed the lid however it still says its open?! I cant check if it is a problem with the lense or the spindle because the lid has to be detected shut before they can run. Any help would be appreciated, thanks!
Andrew Olores: Nice video bro.....
EvelynProductions1: Thanks!!!! My dad will check out my little sister and I DVD players. :)
tnt1237: ya about removing the cover.......haha its kinda built into my tv
george mackin: Thanks my friend.
Bob McCloskey: Rubber bands dry out fairly quickly. I used the neck of a balloon! I cut it off the balloon, stretched it over the pullys and it works perfectly!
Lilylibra: Thank you x
fredwilma1000: Nice one mate thanks.
Danny Lam: Yes!!! It DOES work!!!!!! Thanks so much! :D
Raj Dann: its called a belt........
phantomempire: if rubber band doesnt work , you can go to any hardware store and get a ''rubber ''o '' ring.. for about 59cents ,i did , and it works fine!!!
MorrisMcKinnon08: Why do we put up with this cheep'n'nasty japanese crap? Nothing lasts anymore. When it breaks down it's way to expensive to repair and ends up in the bin in a couple of years! Looking inside these though i wonder why it is so expensive to repair DVDs.You remove the defective board inside and replace with a new one. Gone are the days of replacing individual caps and resistors which odlly enough was harder to do yet worth doing. My 1980's VCR still works! i'd love to see any DVD last that long!
Shasha790: Do you know to fix a door of a DVD player. I have the same kind of door that you have on this dvd player here where the door goes down so the tray can come out.
ctm aqil: I like it good and its work now my dvd is ok so my father wont take out the money to buy new 1 thank like it
keirarocksme: the dvd player doesn't play? if so the lens may be the problem... adjust the potentiometer under the lens assembly, just be carefull..
Beepers100: Awesome. But how do you fix the part that spins the dvd?
Walt Dizzy: I have this exact same problem but i cant find my two sprocket things =( damn JVC.
Hair Do: Thanks for the tip. I do know it's hard to earn money. But it is much better than working minimum wage at mcdonolds. Being an hair stylist does get tips and I end up making decent money. Plus it allows me to be creative sometimes and make customer's dream come to reality.