DJI Naza 3 Flight Modes (Attitude, Manual, And GPS) W/ Turnigy 9X Transmitter And 3 Position Switch




What do you think about this video?

Rodrigo Eleutério: GOOD DAY, NEED HELP, RODE A QUAD TBS FRAME WITH NAZA LITE AND RADIO Turnigy 9X, FIZ SETUP RADIO AND MODES OF FLIGHT ALL RIGHT, I flew WITH QUAD PERFECT ... BUT THERE BEGINS THE PROBLEM WHEN I hung up and I called again did not select MORE THE FLIGHT MODES AND PARENT NOT GUN OVER ANY WAY ... WHAT CAN BE ??? I checked CABLES, I replaced the receiver, reconfigured AND NOTHING HAPPENS, THE LED OF NAZA IS IN tx signal lost ... WHAT SHOULD I DO ... help me please (Message translated by Google)

Remy Martin: Dennis,

After a bad crash that bent a the metal rod that goes down the middle, losing a camera, a prop flying off ( which caused it obviously 'myfault') and losing a $40 camera. I rebuilt it with some spare parts.

I decided to do a fail safe while losing TX signal and along with installing a new (to me) RX (X8R) and your videos she is back in the air with more confidence than before.

Thank you again for all the great tutorials that you have provided this hobby! Extremely invaluable!

Remy

Bello3: What's the diference betwen GPS and ATTI?

Spoif: Power and ground are only really needed on one connection between the flight controller and RX. You can put the other 3 way leads sideways on the signal pins of the channels, reducing the number of wiring harnesses needed between the two devices.

Dale 01938: Do you have a video on IOC settings Homelock and course lock?

Toxicate3: I'm using ppm and for some reason my channel 7 is linked to Control mode switch and my pit curve is linked to X2. I managed to mess around in the mix settings and get 3 position switch to channel 7. However i can only get as far as Atti. eg. I have it set to atti failsafe and manual, Could someone help its really frustrating.

QuadNet Hardy: Thank you, for posting this video. Can you please make a video how to add a sonar sensor on Naza M Lite

ayman fatani: I just bought Flysky th-x9 its as same as Turnigy transmitter, I followed your vid and everything worked just great, Thanks a bunch lad

ayman fatani: You are just AWESOME dennis I like you man you are my best 

ayman fatani: Hey there denny, Can I use my Turnigy 6x with Naza Lite ? coz I have an issue when trying to do that, the Naza flashes yellow so fast and keeps in that situation :(, when the Tx is OFF the mode switches to ALT mode, and when ON it switches to the far right " EMPTY LITTLE BOX" !!!!!!!! any HELP please, does this trans. supports Naza lite ? Thanks in Advanced

Gabriele Barbaraci: can you please provide instructions step by step for a complete configuration of Turnigy 9X with DJNAZA?

Arthur Hohn: Is it possible to do one on the Flysky FS-i10 for Naza?  thank you awesome vid

Joe Anthing: having trouble actually linking the 3 pos switch to control that. It is linked on the receiver to channel 7 (6 for some reason links to the throttle). 

tony13985: I understand that there is no failsafe for FS Rx, but is there a way to activate manually the RTH feature using this Tx?

nalasala: Great video. Thanks. 

eldhose nariyelil: I did the calibration but nope, the rudder is still staying 2 points towards right.
If i factory reset the turnigy 9x, do i have to bind it again to work or all i gotta do is the put the values and settings back again? I wanna try that if i dont have to bind it 

eldhose nariyelil: Hi dennis
Thank you so much for showing us how to set the radio up
But im having a problem with my rutter instead of lining up in the middle and being green its stays 3 marks towards the right, i adjusted the sub trim but it is not centering i did calibration but no help
So please help me out
Thanks 

Jared Cruthird: dennis, i have settup up my discovery with nava v2 and turnigy 9x according to your video and every thing works accordingly except for manual mode. It shows on naza software when i toggle 3 position switch and highlights blue above gps, att, but not manual the arrow below it is centered but will not highlight it just goes to failsafe. any ideas?

Dario Pupi: Hi i have a turnigy 9x too. The manual of naza says i need to use a new model in the radio as AIRPLANE mode.... i see you are using the HELI mode... did you find some problems? is not a problem use HELI mode? I'd like to use heli mode too because is more simple for set the switches on the radio...

Rating:
DJI Naza 3 Flight Modes (Attitude, Manual, and GPS) w/ Turnigy 9X Transmitter and 3 Position Switch 5 out of 5

Shared by Others

DJI Naza 3 Flight Modes (Attitude. Manual. and GPS) w/ Turnigy 9X Transmitter and 3 Position Switch
DJI Naza 3 Flight Modes (Attitude. Manual. and GPS) w/ Turnigy 9X Transmitter and 3 Position Switch
How to Configure DJI Naza Control Modes (Attitude and Manual) with Turnigy 9x Transmitter
How to Configure DJI Naza Control Modes (Attitude and Manual) with Turnigy 9x Transmitter
Turnigy 9x Transmitter & 3 Mode Auxiliary Switch for Different Flight Modes with APM 2.5 Quadcopter
Turnigy 9x Transmitter & 3 Mode Auxiliary Switch for Different Flight Modes with APM 2.5 Quadcopter
QAV400 - NAZA Wiring. Configuration. and 3 Flight Modes w/ Turnigy 9X in ACRO Model Type
QAV400 - NAZA Wiring. Configuration. and 3 Flight Modes w/ Turnigy 9X in ACRO Model Type
Turnigy 9X Transmitter Three Position Switch Nova/Storm OSD Flight Mode
Turnigy 9X Transmitter Three Position Switch Nova/Storm OSD Flight Mode
Turnigy 9XR 3 Position Switch for Different Flight Modes w/ NAZA Lite and TBS Discovery Quadcopter
Turnigy 9XR 3 Position Switch for Different Flight Modes w/ NAZA Lite and TBS Discovery Quadcopter
Turnigy9x NAZA GPS Forced Fail-Safe Mix
Turnigy9x NAZA GPS Forced Fail-Safe Mix
FrSky Taranis 3 Flight Modes and Forced Failsafe Override with DJI NAZA on QAV400 Quadcopter
FrSky Taranis 3 Flight Modes and Forced Failsafe Override with DJI NAZA on QAV400 Quadcopter
NAZA Lite and NAZA V1 GPS Mounting. Configuration. Calibration with Walkera 3 Mode Switch
NAZA Lite and NAZA V1 GPS Mounting. Configuration. Calibration with Walkera 3 Mode Switch
DJI Naza Failsafe Without GPS - Part 2 w/ FrSky Turnigy 9X
DJI Naza Failsafe Without GPS - Part 2 w/ FrSky Turnigy 9X
Turnigy 9x - Flaperons using 3 position switch
Turnigy 9x - Flaperons using 3 position switch
Turnigy 9X V2 - DJI NAZA GPS - F. Mode Counter
Turnigy 9X V2 - DJI NAZA GPS - F. Mode Counter
UNBOXING   DJI NAZA V2 AND COMPASS
UNBOXING DJI NAZA V2 AND COMPASS
Flysky/Turnigy 9x Switch Programming For Naza M
Flysky/Turnigy 9x Switch Programming For Naza M
DX6i + Naza-M lite + OrangeRX R620 setup for all 3 modes inc failsafe
DX6i + Naza-M lite + OrangeRX R620 setup for all 3 modes inc failsafe
DJI Naza Basic and Attitude Gain Settings for Pitch & Roll Using Turnigy 9X Control Knobs
DJI Naza Basic and Attitude Gain Settings for Pitch & Roll Using Turnigy 9X Control Knobs
ArduPilot ArduCopter APM 2.5 Configuration with Turnigy 9X Transmitter and Receiver for Quadcopter
ArduPilot ArduCopter APM 2.5 Configuration with Turnigy 9X Transmitter and Receiver for Quadcopter

Featured Video