Dot D: made one for my husband for his birthday. took a few hours but not bad for my first one
Carl Bowden: Nicely done probably much easier than a double cobras, looks nicer too.
sneektip79: This is a good set of instructions. Thank you. I just finished my third sling now. I have made all mine adjustable, with the bottom half being nylon webbing.
Victor Mannahan: If you gut the remaining extra paracord ahead of time (remove the inner strands), you can get a much flatter tuck and way smaller melt points. You should also pre shrink all your paracord in boiling water. It can shrink as much as 15% if it gets wet making for next to impossible stitching removal in an emergency. Thanks for the vid!
Mark LaFlamme: Fantastic video. I was pulling my hair out trying to figure out this weave through other videos. This one goes slow for simpletons like me and the still photos really helped. Don't get me wrong: I STILL screwed mine up, but that's not the fault of the video. I did one thing wrong in the beginning and it set me off on a bad course. My sling looks like the tail of a scrawny, gangrenous sewer rat at the moment. I'm still not sure what went wrong. It's a mystery for the Knot Police, I guess.
armybrat707: I have a ruger 10/22 I might make one of these slings
David Lister: How long do you have to "cauterize" the paracord before it bleeds out???
lol, great video man, but ladder rack weave looks easier.
time for some fpv action: ship my pants lol funny ad
Evilscarecrow103: Great video! I'm going to make one today
Binaric01: Yes, they use the same sling connectors as guns.
David Jacobo: will that fit a cross bow
Binaric01: In reference to doing the king cobra stitch over a cobra stitch, I think it would look really good (if using two different colors) and give you lots of paracord in the event you needed it. I've watched lots of videos of the king cobra stitch and it appears it's just as flexible as any paracord weave. Just remember, when weaving, to keep it as tight as you can. When doing a sling, I like at least a 1 inch weave to provide better support.
Jhc00Gamerdude: Hey man, I sent you a message (Question about the sling) if you can check it out and get back to me as soon as you can. Thanks and I appreciate it!
JC Paint | Paracord Workz: check out my channel. I have a few how to videos I'm trying to load as we speak. Including the Ladder Rack weave. I have the AK47 shown in a video as well
Binaric01: Didn't know about the Ladder Rack weave. After looking it up, looks easier to make and the whole thing would be one single strap of paracords. Thanks for the suggestion!
JC Paint | Paracord Workz: why not just make the internal and external all 1 solid peice of paracord? I did this with my Pistol AK47 sling! with Ladder Rack weave
jnussear: Great video. Made a sling for my grandfathers rifle, it is exactly what this rifle needed. Thank you.
asiankid717: I made one like this I added 1 inch nylon webbing on the end with a small square d ring and plastic adjusters off an old back pack now I have and adjustable sling
Binaric01: Thanks for the idea, I think I'll work on one that can be adjusted.