Drilling AK Receiver Front Trunion Holes




What do you think about this video?

bretak74: @tux0505 It depends on which hole you're drilling. Watch Buildyourownak's videos and he'll tell you what to use when.

bretak74: @22dramz I have no idea. We got it at work. It was over $2000 if I remember correctly.

bretak74: @dills2403 The trunnion already has holes. Prior to sliding the receiver on, the trunnion is clamped in place and positioned so the drill bit will travel through the hole and its opposite. The receiver is then slid in place, clamped to the trunnion, and the holes are drilled.

dan ram: where do u buy that big drill machine?
Rating:
Drilling AK Receiver Front Trunion Holes 5 out of 5

Shared by Others

Full Heat Treat of AK Receivers
Full Heat Treat of AK Receivers
Drilling the PZ aluminum trunnions
Drilling the PZ aluminum trunnions
Measuring barrel journals
Measuring barrel journals
RPK Barrel Assembly Part 3 Pressing on Gas Port
RPK Barrel Assembly Part 3 Pressing on Gas Port
Spot Welding Rails
Spot Welding Rails

Featured Video